Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1
- Overview
- Chapter 2 :
- Chapter 3
- Chapter 4
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Troubleshooting
- Appendix A
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
47
AC Power Connector
The x600 switches have a single AC power supply socket on the rear
panel, which has autoswitch AC inputs. To power the switch on or off,
connect or disconnect the power cord.
Refer to “Technical Specifications” on page 101 for the input voltage
range.