Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1
- Overview
- Chapter 2 :
- Chapter 3
- Chapter 4
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Troubleshooting
- Appendix A
x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide
29
XFP Transceiver Slots
The x600-24Ts/XP and the x600-48Ts/XP Switches have two slots for
optional XFP 10 Gigabit Ethernet transceivers that you can use to connect
high speed, 10 gigabit devices to the switch or to create high speed
backbone networks between switches. Figure 7 shows an example of an
XFP transceiver.
Figure 7. XFP Transceiver
Refer to “Installing an XFP Transceiver” on page 83 for the XFP
installation instructions.
Note
For a list of supported XFP transceivers, contact your Allied Telesis
sales representative.
721