Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1
- Overview
- Chapter 2 :
- Chapter 3
- Chapter 4
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Troubleshooting
- Appendix A
Chapter 1: Overview
20
Introduction
The x600 Series Switches are managed Gigabit Ethernet switches that act
as standalone units. There are five Basic Layer 3 switches in the series:
x600-24Ts Switch
x600-24Ts/XP Switch
x600-48Ts Switch
x600-48Ts/XP Switch
x600-24Ts-POE Switch
The AlliedWare Plus
Operating System Software (AW+) runs on all the
x600 switches. The x600-24Ts-POE requires AW+ software version 5.3.3
or later for IEEE 802.3af support
For more detailed information about the switches, including illustrations,
see “Switch Descriptions” on page 21.