Installation Guide

GS950PS V2 Series Quick Installation Guide 7
Note: The GS950/52PS V2 Switch does not include the eight wall
screws, washers, and wall anchors.
Choosing a Site for the Switch
Review these site recommendations and requirements.
 Before installing the switch in an equipment rack, verify that the
rack is safely secured so that it will not tip over. Devices in a rack
should be installed starting at the bottom of the rack, with the
heavier devices near the bottom.
 Before installing the switch on a table, verify that the table is level
and stable.
 Before installing the switch on a wall, verify that the wall’s material
is strong enough to hold the switch’s weight. You should position
the device so that it can be screwed into the wall’s framing timber
or equivalent structural element.
 The power outlet should be located near the switch and be easily
accessible.
 The site should allow for easy access to the ports on the front of
the switch so that you can easily connect and disconnect cables,
and view the port LEDs.
Equipment rack/wall brackets
for the GS950/10PS V2 switch
Equipment rack/wall brackets
for the GS950/18PS V2 and
GS950/28PS V2 switches
Equipment rack brackets for
the GS950/52PS V2 switch