System information

9
How to work with command modes
How to work with command modes
The following figure shows the command mode hierarchy and the commands to use to move
to lower-level modes.
User Exec mode is the mode you log into on the switch.
It lets you perform high-level diagnostics (show commands, ping, traceroute etc), start
sessions (Telnet, SSH), and change mode.
For a list of commands available in this mode, see "User Exec mode" on page 39.
The default User Exec mode prompt is awplus>.
 User Exec mode
AlliedWare Plus CLI modes
User
Exec mode
Privileged
Exec mode
Router
mode
Interface
mode
enable
Command used to
enter the next
command mode
Command mode
configure terminal
interface
[interface name]
router [routing
protocol ]
Other
sub-modes
Global
Configuration
mode
cli-modes.eps