- Allied Hub/Switch User Guide

Layer 2 Switching 39
Rapier Switch Software Release 2.2.1
C613-02013-00 Rev A
Figure 10: Example output from the SHOW VLAN command.
VLAN Information
------------------------------------------------------------
---------------
Name ............... default
Identifier ......... 1
Status ............. static
Untagged ports ..... 1,3-23
Tagged ports ....... None
Spanning Tree ...... default
Trunk ports ........ None
Mirror port ........ None
Attachments:
Module Protocol Format Discrim MAC address
-----------------------------------------------------------
--------
GARP Spanning tree 802.2 42 -
-----------------------------------------------------------
--------
Name ............... v2
Identifier ......... 2
Status ............. dynamic
Untagged ports ..... 2,24
Tagged ports ....... None
Spanning Tree ...... default
Trunk ports ........ None
Attachments:
Module Protocol Format Discrim MAC address
-----------------------------------------------------------
--------
GARP Spanning tree 802.2 42 -
-----------------------------------------------------------
--------
Table 5: Parameters displayed in the output of the SHOW VLAN command
Parameter Meaning
Name The name of the VLAN.
Identifier The numerical VLAN identifier of the VLAN.
Status The status of the VLAN, either dynamic or static.
Untagged Ports A list of untagged ports that belong to the VLAN.
Tagged Ports A list of tagged ports that belong to the VLAN.
Spanning Tree The name of the Spanning Tree Protocol to which the VLAN
belongs.
Trunk ports The list of switch ports which belong to trunk groups. This
field is displayed if any port in the VLAN also belongs to a
trunk group.
Mirror port The mirror port for the switch, or “None”. Displayed for the
default VLAN only.
Attachments
This section contains information about attachments to the
VLAN made by other modules in the switch.
Module The name of the software module attached to the VLAN.