Switch User Manual

14 System Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
Example To display the extended CPU utilisation data, use the command:
sh cpu ext
Table 1: New parameters in output of the show cpu=extended command
Parameter Meaning
State Whether extended CPU utilisation is enabled.
Current Time Current time in hh:mm:ss format. The time in
milliseconds since midnight, and the current timestamp
are also in brackets.
Current Install Current installed release, with the size of the release in
brackets.
Start percent Percentage of utilisation that the CPU must reach, if any,
before the router or switch can begin capturing
extended CPU utilisation data. A “-” shows if no
percentage is set.
Stop percent Percentage of utilisation that the CPU must fall below
before the router or switch stops capturing extended
CPU utilisation data.
msSM Time when the router or switch captured the CPU
utilisation sample. The time format is milliseconds since
midnight, in hexadecimal notation.
Timestamp Time when the router or switch captured the CPU
utilisation sample. The time format is microseconds
since the router or switch last restarted. This figure
wraps at 4 294 967 295 to return to 0.
Util Percentage of instantaneous CPU utilisation.
Caller Return address of the function that the CPU is
executing.
Return 1, Return 2, Return 3 Return addresses for function calls on the CPU stack.