Switch User Manual

Software Version 2.8.1 135
Software Version 2.8.1
C613-10477-00 REV B
Example To assign policy 2 to port group 1, and name the port group “uplink”, use the
command:
set qos portg=1 poli=2 desc=uplink
set qos trafficclass
Syntax set qos trafficclass=trafficclass-list
[stormstatus={enable|disable}]
[stormwindow={windowsize|none}][stormrate={rate|none}]
[stormaction={linkdown|portdisable|vlandisable}]
[stormtimeout={timeoutlength|none}]
[other-parameters]
POLIcy Policy to attach or remove for this port group.
Default: no default
policy-list Integer from 0 to 255 for a specific policy.
NONE Removes policy currently assigned to the port group.
DESCription Description of the port group.
Default: no default
Parameter (cont.) Description (cont.)
Parameter Description
STORMStatus Whether storm protection is enabled for the default traffic class.
Default: disabled
STORMWindow Time between the polling of traffic class counters that checks
whether storm protection should be activated. Required when storm
protection is enabled.
Default: none
windowsize Number of milliseconds from 100 to 60 000.
NONE Storm protection is inactive.
STORMRate Storm protection is activated when this rate of traffic is exceeded.
Required when storm protection is enabled.
If the value of stormwindow is less than one second, the rate is
averaged over the last second.
Default: none
Rate Bits per second from 1Kbps to 10Gbps, specified in
Kbps, Mbps or Gbps. If you do not specify a unit, it
uses Kbps. If you specify Mbps or Gbps, the rate may
contain a decimal fraction with up to 3 decimal
places, for example, 1.25 Mbps.
NONE Storm protection is inactive.