Switch User Manual

Software Version 2.8.1 111
Software Version 2.8.1
C613-10477-00 REV B
show bgp peer
Syntax SHow BGP PEer[=ipadd]
Description When you specify a peer, the output of this command includes a new field.
Figure 30: Example output of the show bgp peer command for a specific peer
show bgp route
Syntax SHow BGP ROUte[=prefix]
[COMmunity={INTernet|NOAdvertise|NOExport|
NOEXPORTSubconfed|aa:xx}[,...]}] [PEer=ipadd]
[REGexp=aspathregexp]
Description The new peer parameter specifies the IP address of the peer. If you specify a
peer, the router or switch only displays routes that it learned from that peer. If
you specify the router or switch’s router ID, it displays all locally originated
routes. The peer parameter has no default.
Note that this enhancement did not change any fields in the output of the show
bgp route command; it simply provides another method of filtering the
displayed routes.
Peer ................ 192.168.10.1
Description ......... -
State ............... Idle
Policy Template ..... 4
Description ......... Test Template 1
Private AS filter ... Yes
Remote AS ........... 3
BGP Identifier ...... 172.20.25.2
Routes learned ...... 15
Authentication ...... None
Password .......... -
.
.
.
Table 28: New parameters in the output of the show bgp peer command
Parameter Meaning
Routes learned The number of routes that the router or switch has learned from this
peer.