Manual

Appendix D: Command Line Interface (CLI) for Access Point Configuration
348
Rebooting the
Access Point
To reboot the access point, type reboot at the command line:
AT-WA7400# reboot
Resetting the
Access Point to
the Factory
Defaults
If you are experiencing extreme problems with the AT-WA7400 Wireless
Access Point and have tried all other troubleshooting measures, you can
reset the access point. This will restore factory defaults and clear all
settings, including settings such as a new password or wireless settings.
The following command resets the access point from the CLI:
AT-WA7400# factory-reset
Note
Keep in mind that the
factory-reset command resets only the
access point you are currently administering; not other access
points in the cluster.
For information on the factory default settings, see Appendix A,
“Management Software Default Settings” on page 215.