Instruction Manual

Allied Telesyn AT-VIEW PLUS
AMIGO
PN 613-50506-00 Rev B Page 7 of 38
2.1 Starting From the Command Line
The command line interface is the most basic way to start AMIGO.
Topics:
• Command Syntax
• Target Host
• Get Community
• Set Community
• Configuration File
• Parameter File
2.1.1 Command Syntax
To start AMIGO from the command line, use the following syntax.
Amigo [options]
You can specify the following options.
TargetHost
The IP address or hostname of the target host.
GetCommunity
SNMP Get community string. This is used to retrieve MIB values.
SetCommunity
SNMP Set community string. This is used to modify MIB values.
xxx.amg file
The name of the AMIGO configuration file. This has the extension .amg.
Note - If a configuration file is specified along with the other parameters, the contents of the
configuration file will take precedence.