Datasheet

ManualsBrandsAllied Telesis ManualsNetworkingAT-STACKXS/1.0

100

Table Of Contents

Contents
Figures
Tables
Preface
- Document Conventions
- Contacting Allied Telesis
Chapter 1
Overview
- Features
- Front and Rear Panels
- Management Panel
- 10/100/1000Base-T Twisted Pair Ports
- SFP+ Slots
- Stacking SFP+ Slots
- eco-friendly Button
- LEDs
- USB Port
- Console Port
- Power Supplies
Chapter 2
Virtual Chassis Stacking
- Overview
- Stacking Slots
- Stacking Transceivers
- Stacking Port Topologies
- Master and Member Switches
  - Selection of the Master Switch
  - ID Numbers
- Specifying Ports in the Command Line Interface
Chapter 3
Beginning the Installation
- Reviewing Safety Precautions
- Choosing a Site for the Switches
- Planning a Stack
- Unpacking the Switch
Chapter 4
Installing the Switches on a Table or in an Equipment Rack
- Installing the Switches on a Table or Desktop
- Installing the Switch in an Equipment Rack
Chapter 5
Verifying the Status of VCStack
- Verifying the Status of VCStack
- Activating the VCStack Feature
  - Starting a Local Management Session
  - Activating VCStack
Chapter 6
Cabling the Stacking Ports
- Cabling Switches with AT-StackXS/1.0 Transceivers
- Cabling Switches with AT-StackOP/0.3 or AT-StackOP/9.0 Transceivers
Chapter 7
Powering On the Stack
- Powering On the Switches Individually
- Powering On the Switches Simultaneously
- Verifying the Stack
  - Setting the Priority Numbers
- Monitoring the Initialization Processes
Chapter 8
Cabling the Networking Ports
- Cabling the Twisted Pair Ports
- Installing SFP and SFP+ Transceivers
Chapter 9
Troubleshooting
Appendix A
Technical Specifications
- Physical Specifications
- Environmental Specifications
- Power Specifications
- Certifications
- Quality and Reliability
- RJ-45 Twisted Pair Port Pinouts
- RJ-45 Style Serial Console Port Pinouts
- Fiber Optic Specifications of the AT-StackOP/0.3 and AT-StackOP/9.0 Transceivers

x510 Series Installation Guide for Virtual Chassis Stacking

Figure 47. Removing the Dust Plug from an SFP+ Slot

Note

When VCStack is enabled on the switch, slots S1/27 and S1/28 on

the AT-x510-28GTX Switch and slots S1/51 and S1/52 on the AT-

x510-52GTX Switch are reserved as stacking ports and may not be

used for regular SFP or SFP+ transceivers.

2. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

3. If you are installing the transceiver in a top slot, position the transceiver

with the Allied Telesis label facing up. If you are installing the

transceiver in a bottom slot, position the transceiver with the label

facing down.

4. Slide the transceiver into the slot until it clicks into place, as shown in

Figure 48 on page 96.