Datasheet

x510 Series Installation Guide for Virtual Chassis Stacking
77
Figure 36. Removing the Dust Cover from a Stacking Transceiver
5. Verify the position of the handle on the transceiver. If the transceiver is
in the S1 slot, the handle should be in the upright position, as shown in
Figure 37. If the transceiver is in the S2 slot, the handle should be in
the down position.
Figure 37. Positioning the Handle in the Upright Position
6. Connect the fiber optic cable to the transceiver, as shown in Figure 38
on page 78. The connector on the cable should fit snugly into the port,
and the tab should lock the connector into place.
SFP Handle