Datasheet

ManualsBrandsAllied Telesis ManualsNetworkingAT-STACKXS/1.0

Table Of Contents

Contents
Figures
Tables
Preface
- Document Conventions
- Contacting Allied Telesis
Chapter 1
Overview
- Features
- Front and Rear Panels
- Management Panel
- 10/100/1000Base-T Twisted Pair Ports
- SFP+ Slots
- Stacking SFP+ Slots
- eco-friendly Button
- LEDs
- USB Port
- Console Port
- Power Supplies
Chapter 2
Virtual Chassis Stacking
- Overview
- Stacking Slots
- Stacking Transceivers
- Stacking Port Topologies
- Master and Member Switches
  - Selection of the Master Switch
  - ID Numbers
- Specifying Ports in the Command Line Interface
Chapter 3
Beginning the Installation
- Reviewing Safety Precautions
- Choosing a Site for the Switches
- Planning a Stack
- Unpacking the Switch
Chapter 4
Installing the Switches on a Table or in an Equipment Rack
- Installing the Switches on a Table or Desktop
- Installing the Switch in an Equipment Rack
Chapter 5
Verifying the Status of VCStack
- Verifying the Status of VCStack
- Activating the VCStack Feature
  - Starting a Local Management Session
  - Activating VCStack
Chapter 6
Cabling the Stacking Ports
- Cabling Switches with AT-StackXS/1.0 Transceivers
- Cabling Switches with AT-StackOP/0.3 or AT-StackOP/9.0 Transceivers
Chapter 7
Powering On the Stack
- Powering On the Switches Individually
- Powering On the Switches Simultaneously
- Verifying the Stack
  - Setting the Priority Numbers
- Monitoring the Initialization Processes
Chapter 8
Cabling the Networking Ports
- Cabling the Twisted Pair Ports
- Installing SFP and SFP+ Transceivers
Chapter 9
Troubleshooting
Appendix A
Technical Specifications
- Physical Specifications
- Environmental Specifications
- Power Specifications
- Certifications
- Quality and Reliability
- RJ-45 Twisted Pair Port Pinouts
- RJ-45 Style Serial Console Port Pinouts
- Fiber Optic Specifications of the AT-StackOP/0.3 and AT-StackOP/9.0 Transceivers

x510 Series Installation Guide for Virtual Chassis Stacking

Figure 32. Removing the Dust Plug from the S2 Slot

6. Remove the dust cover from the connector on the other end of the

transceiver.

7. Position the transceiver with the release tab on the bottom and slide it

into the slot until it clicks into place, as shown in Figure 33 on page 74.