Instruction Manual

Page 61
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Example
The following example adds the MAC-layer address 66:66:66:66:66:66 to port 1/e1.
show bridge address-table
The show bridge address-table Privileged EXEC mode command displays all entries in the bridge-forwarding
database.
Syntax
show bridge address-table [vlan vlan] [ethernet interface | port-channel port-channel-number]
Parameters
•
vlan — Specifies a valid VLAN, such as VLAN 1.
• interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
•
Internal usage VLANs (VLANs that are automatically allocated on ports with a defined Layer 3 interface) are
presented in the VLAN column by a port number and not by a VLAN ID.
• "Special" MAC addresses that were not statically defined or dynamically learned are displayed in the MAC
Address Table.
Example
The following example displays all classes of entries in the bridge-forwarding database.
console(config)# interface ethernet 1/e1
console(config-if)#
port security routed secure-address 66:66:66:66:66:66
console#
show bridge address-table
Aging time is 300 sec
vlan mac address Port Type
--------- -------------- ---- -------
1 00:02:3f:b4:28:05 e16 dynamic
1 00:07:40:c9:5f:83 ch5 dynamic
1 00:15:77:74:64:40 ch5 dynamic