Instruction Manual

Page 183
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
User Guidelines
There are no user guidelines for this command.
Example
The following example restarts the LLDP RX state machine and clears the neighbors table.
show lldp configuration
The show lldp configuration Privileged EXEC mode command displays the LLDP configuration.
Syntax
show lldp configuration [ethernet interface]
Parameters
•
interface — Ethernet interface.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the Link Layer Discovery Protocol (LLDP) configuration:
console(config)# clear lldp rx ethernet e15
console# show lldp configuration
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Port State Optional TLVs Address
---- ----- ------------- -------
1/e1 RX, TX PD, SN, SD, SC 172.16.1.1
1/e2 TX PD, SN 172.16.1.1
1/e3 Disabled