Manual

92
Chapter 11
Basic Multiplexer Commands
This chapter contains the following commands:
Command Function Page
SET IP
Sets the multiplexer’s IP address,
subnet mask and gateway address.
94
SHOW IP
Displays the multiplexer’s IP
address, subnet mask and gateway
address.
96
ENABLE BOOTP
Enables BOOTP. 97
DISABLE BOOTP
Disables BOOTP. 98
SHOW CONFIG
Displays the multiplexer’s
configuration.
99
SET SYSTEM
Sets the multiplexer’s name,
location, and contact.
100
SHOW SYSTEM
Displays the multiplexer’s name,
location, and contact.
101
SET SNMP COMMUNITY-
STRING
Sets the Get, Set, and Trap
community strings.
102
SET SNMP TRAP
Sets which traps the management
workstations are to receive.
103
SHOW SNMP
Displays the community strings and
the IP addresses of management
workstations to receive traps.
105
PING
Instructs the multiplexer to ping a
network node.
106