Manual

77
Chapter 9
Getting Started
Starting a Command Line Management Session
In order to manage an AT-WD1008 multiplexer using the command line
commands, you must first start a local or Telnet management session.
The instructions for starting a management session are described in
Chapter 1, Getting Started on page 14.
Once you have started a local or Telnet management session, you will
see the AT-S47 Main Menu. This menu will have the following option as
one of its selections:
❑ Command line interface
Selecting this option displayed the command line prompt “%”, as shown
in Figure 33. You are now ready to manage the switch using the
command line commands.
Figure 33 Command Line Interface Prompt
Allied Telesyn Gigabit Ethernet Wavelength Division Multiplexer
MAC Address 009099 79B1D5
AT-S47 Management Module Software: Version 1.0.0 B07 030324
Running 3 hours, 15 minutes, 24 seconds
SIGMA command shell version 1.0.0
%