Manual

AT-S47 Management Software User’s Guide
121
DISABLE MODULE LINKTEST
Syntax
disable module=9|10|all linktest
Parameters
module Specifies the multiplexing port whose Link Test
feature you wish to deactivate.
❑ 9 - WEST
❑ 10 - EAST
❑ ALL - WEST and EAST
Description
This command deactivates the Link Test feature on a multiplexing port.
Note
A Link Test must be stopped in the same manner in which it was
started. If you started the test using the AT-S47 interface, either the
menus or command line, then you must stop it using the AT-S47
interface. If you started the test using the Link Test button on the
chassis, then you should use the button to end it.
Example
The following command deactivates the Link Test feature on the WEST
multiplexing port of the multiplexer:
disable module=9 linktest
The following command deactivates the Link Test feature on both
multiplexing ports of the multiplexer:
disable module=all linktest