Operation Manual

16 AT-RG613/623TX Series Residential VoIP Gateway - User Manual

Wall mounting the RG613/623TX:

1. Using the wall mount bracket as a template drive 3 drywall screws

horizontally into the plywood towards the top and to either side of the

available space. If plywood is not available, then use the wall mount

bracket to mark the 3 hole locations and pre-drill for the drywall anchors,

then drive the screws through the holes.

2. Hang the RG613/623TX as described in Figure 26.

Figure 25: Positioning of the wall bracket

The diameter of screw hole is 3.5mm.

Use 3mm x 2.5 cm screws and, if necessary,

drywall anchors.

Figure 26: Possible layouts

If you install the device in an elevated position, ensure it is securely connected

to the wall, if not it may drop and cause injury or it may be damaged itself.

Do not install where there may be vibrations, shocks or in an unsuitable place.

When you install this product on the wall it could be damaged if the unit should

drop. Please be careful.

Please note that the maximum recommended operating ambient is 40