Operation Manual

AT-RG213 Residential VoIP Gateway - SIP Software Reference Manual
SIP Software Release 6-0-0
J613-M0524-00
64
DISABLE L2TP
Syntax
DISABLE L2TP
Short Syntax
DIS L2TP
Description
This command disables the L2TP module, closes session and tunnel active
and release all the allocated resources.
Examples
To disable the L2TP tunnel, use the command:
DISABLE L2TP
See also
ENABLE L2TP
CREATE L2TP
DELETE L2TP
SHOW L2TP
CREATE L2TP
Syntax
CREATE L2TP LNSIP=ipaddr LOCALTUNNELIP=ipaddr
[PASSWD=passwd]
where:
 ipaddr : is an IP address in dotted decimal notation.
 passwd : is a character string, 1 to 20 characters in length, in either lower or
upper case. Valid characters are letters (a ÷ z, A ÷ Z) and digits (0 ÷ 9). The
string cannot contain any spaces.
Short Syntax
C L2TP LNSIP=ipaddr LTUNIP=ipaddr [PASSWD=passwd]
Description
This command creates a L2TP tunnel between the RG and the LNS server
specified into the command line.
If an error occurs during the tunnel establishment, this procedure is
repeated every 30 seconds until the tunnel establishment process is
complete.
If one of Call Disconnect Notify or Stop Control Connection Notification
message is received the session and the tunnel will be closed; after 30
seconds the RG will start retrying to establish a new tunnel session.
The LNSIP parameter specifies the IP address of the remote L2TP server.
The LOCALTUNNELIP parameter specifies the IP address of the local L2TP
LAC.
The PASSWD parameter specifies a password to be used to authenticate the
tunnel creation with the remote L2TP server (encrypted using MD5
method).
This is the password that LNS is receiving from RG.
Examples
To create a L2TP tunnel between the local L2TP LAC with IP address