Operation Manual

SIP
SIP Software Release 6-0-0
J613-M0524-00
53
USR=[e-mail] A-PWD=welcome
PS=192.168.0.10 DO=alliedtelesyn.com
LS=192.168.0.10 CAP=G723; PCMU
DELETE SIP PORT
Syntax
DELETE SIP PORT=port
Short Syntax
D SIP PORT=port
where:
 port is the physical port number (can be 0 or 1)
Description
This command allows deleting a port from the SIP stack. Any ongoing call
will be terminated as effect of command execution.
Examples
To delete the port 0:
DELETE SIP PORT=0
DISABLE SIP
Syntax
DISABLE SIP
Short Syntax
DIS SIP
Description
This command disables the SIP module and frees all the allocated resources.
Please note that this command terminates any ongoing call.
Examples
To delete enable the SIP module:
DISABLE SIP
ENABLE SIP
Syntax
ENABLE SIP [DEFAULTPORT=port] [NATIP=ipaddr]
Short Syntax
EN SIP [DP=port] [NI=ipaddr]
Description
This command enables the SIP module. This must be called before any other
command of this section.
If the AT-RG213 is behind a NAT it is possible to SET the NAT IP address