Operation Manual

AT-RG213 Residential VoIP Gateway - SIP Software Reference Manual

SIP Software Release 6-0-0

J613-M0524-00

Figure 14. LAN SIP endpoint --> AT-RG213 --> Phone

Configuration Examples

Create and configure SIP Port

To create and configure a SIP port, follow the steps below:

Step 1: Enable SIP module:

ENABLE SIP



This command must be executed before any other command concerning this session

Step 2: Create and configure the SIP protocol on a specific voice port and

assign the telephone number.

For example, to assign the telephone number 1000 to the port tel1 (physical

port 0) and enable all allowed coding methods, using the IP Address

192.168.0.10 as Location and Proxy server and alliedtelesyn.com as Domain

use: