Operation Manual

Operation
SIP Software Release 6-0-0
J613-M0524-00
5
HELP [module]
If the module is not specified, a list of available modules is displayed (see
Table 7 for available Modules). The HELP command displays information
from the system help file store in FLASH memory.
Table 7. Available modules
Module name Description
BASIC
Basic device management and
configuration
DNS
DNS Client management and
configuration
IP
IP network management and
configuration
L2TP
L2TP module management and
configuration
PHONE
FXS phone interface management
SIP
SIP module management and
configuration
SNMP
SNMP version 2 management protocol
SW
Integrated switch management
Configuration Examples
Configuration Script
When powered, the AT-RG213 executes the commands in the boot script in
order to obtain the default configuration. A boot script is a sequence of
standard commands executed at start-up. A script file (e.g test.cfg) can be
defined for the following start-up as the boot script using the command:
SET CONFIG=test.cfg
A configuration file is a script made up of the same commands as are used in
the CLI. This file can be edited manually using the CLI, or uploaded from a
terminal that must be a TFTP server.
Saving Configuration Entered with the CLI
Subsequent commands entered from the command line or executed from a
script, do not cause any permanent change in the equipment configuration
and the setting is effective until the device is power cycled. Changes are not
automatically stored in non-volatile memory. When either the AT-RG213 is