Operation Manual

AT-RG213 Residential VoIP Gateway - SIP Software Reference Manual
SIP Software Release 6-0-0
J613-M0524-00
2
Getting Started
The AT-RG213 is supplied with default settings that allow it to operate
immediately as a Residential Gateway. Even if this is all you want to use the
gateway for, you should still gain access to the gateway configuration, if
only to change the manager password to prevent unauthorised access.
The AT-RG213 is provided with a Command Line Interface (CLI) for
configuration and management.
Hardware and Software Requirements
In Table 3, the hardware and software requirements are listed.
Table 3. Hardware and Software requirements
Requirement Description/use Mandatory
VoIP SERVER Endpoint registration (Gatekeeper)
NO
Phone/fax A standard analog telephone or fax
YES
PSTN Line
NO
DHCP Server This server supplies all network
parameters to AT-RG213, if present.
NO
TFTP Server For remote software updates
NO
Terminal Emulation
Software
CLI
YES
Command Line Interface
To use the command line interface (CLI) for configuring the AT-RG213, the
first thing you need to do after physically installing the AT-RG213 is to start
a terminal session to access the AT-RG213. Table 4 lists some common names
for this software, based on the Operating System you are using.
Table 4. Terminal Emulation Software
Operating System Software Name
Windows
9X,Windows
NT/W2K/XP
HyperTerm (included whith Windows software)
Macintosh OS ProComm, VersaTerm
Linux Minicom
The terminal emulation software is used to change the settings and
communicate through your PC with the AT-RG213.
To start a terminal session, do one of the following: