Operation Manual

Switch
SIP Software Release 6-0-0
J613-M0524-00
97
Table 26. Parameters displayed in the output of the SHOW SWITCH
PORT command.
Parameter Meaning
Port
Port reference.
Description
A description of the port.
Status
The state of the port; one of “ENABLED” or
“DISABLED”.
Link state
The link state of the port, one of “Up” or
“Down”.
Uptime
The count in hours:minutes:seconds of the
elapsed time since the port was last reset or
initialised.
Port media type
The MAC entity type.
Configured
speed/duplex
The port speed and duplex mode configured
for this port. One of “Autonegotiate” or a
combination of a speed (one of “10 Mbps”, “100
Mbps” or “1000 Mbps”) and a duplex mode
(one of “half duplex” or “full duplex”).
Acceptable frame type
The value of the Acceptable Frame Types
parameter, one of: “Admit All Frames” or
“Admit Only VLAN-tagged Frames”.
Broadcast rate limit
The limit of the rate of reception of broadcast
frames for this port, in frames per second.
Multicast rate limit
The limit of the rate of reception of multicast
frames for this port, in frames per second.
Current learned,
lock state
The number of MAC addresses currently
learned on this port and the state of locking for
this port. The lock state is one of “not locked”,
“locked by limit” or “locked by command”.
Enabled flow
control(s)
Flow control parameters set for the port; zero,
one or two of “Jamming” and “Pause”. If flow
control is implemented on the switch, then this
kind of flow control is applied to the port.
Send tagged pkts
for VLAN(s)
The name and VLAN Identifier (VID) of the
tagged VLAN(s), if any, to which the port
belongs.
Port based VLAN
The name and VLAN Identifier (VID) of the
port-based VLAN to which the port belongs.
Ingress filtering
The state of Ingress Filtering: one of “ON” or
“OFF”.