Operation Manual

AT-RG213 Residential VoIP Gateway - SIP Software Reference Manual
SIP Software Release 6-0-0
J613-M0524-00
96
MAC Address
The MAC address as learned from the source
address field of a frame, or entered as part of a static
filter entry.
Port
The port from which the MAC address was learned.
Status
Whether the entry was a static filter entry or
dynamically learned; one of “dynamic” or “static”.
SHOW SWITCH PORT
Syntax
SHOW SWITCH PORT[={port-list|ALL}]
Short Syntax
SH SWITCH PORT[={port-list|ALL}]
Where:
 port-list is an identifier or a comma separated list of port identifiers. Port
identifier could be: VOIP, WAN, LAN1, LAN2 and LAN3.
Description
This command displays general information about the specified switch
ports or all switch ports.
Examples
To display the configuration for switch port 1, use the command:
SHOW SWITCH PORT=1
See Also
Figure 27. Example output from SHOW SWITCH PORT command.
0123456789012345678901234567890123456789012345678901234567890123456789
Switch Port Information
---------------------------------------------------------------------------
Port: WAN
Description To intranet hub
Status Enabled
Link state Up
Uptime 00:35:03
Port media type ISO8802-3 CSMACD
Configured speed/duplex Autonegoziate
Actual speed/duplex 100 Mbps, full duplex, MDI
Acceptable frame type Admit all frames
Broadcast rate limit -
Multicast rate limit -
Receive rate limit 9984 kbps
Current learned, lock state 15, not locked
Enabled flow control(s) Jamming
Pause
Send tagged pkts for VLAN(s) marketing (87)
sales (321)
Port based VLAN default (1)
Ingress filtering OFF
---------------------------------------------------------------------------