Operation Manual

AT-RG213 Residential VoIP Gateway - SIP Software Reference Manual
SIP Software Release 6-0-0
J613-M0524-00
94
SET SWITCH QOS DSCP=24,37 PRI=HIGH
See Also
SHOW SWITCH
Syntax
SHOW SWITCH
Short Syntax
SH SWITCH
Description
This command displays configuration information for the switch functions.
Examples
To display the configuration of the switch module, use the command:
SHOW SWITCH
See Also
Figure 25. Example output from the SHOW SWITCH command.
0123456789012345678901234567890123456789012345678901234567890123456789
Switch configuration
---------------------------------------------------------------------------
Switch address 00-00-CD-00-45-C7
Learning ON
Ageing timer ON
Ageing time 300 Sec. (NORMAL)
UpTime 00:01:34
---------------------------------------------------------------------------
Table 24. Parameters displayed in the output of the SHOW SWITCH
command.
Parameter Meaning
Switch address
The MAC address of the switch; it is used as the
source address in pause control frames
.
Learning
Whether or not the switch’s dynamic learning and
updating of the Forwarding Database is enabled.
Ageing timer
Whether or not the ageing timer is enabled.
Ageing time
The value of the ageing timer, after which a dynamic
entry is removed from the Forwarding Database.
UpTime
The time in hours:minutes:seconds since the switch
was last powered up, rebooted, or restarted.
SHOW SWITCH FDB
Syntax
SHOW SWITCH FDB [[ADDRESS=macadd] |
[PORT={port-list|ALL}] | [VLAN={vlanname|1..4094}]]
Short Syntax
SH SWITCH FDB [[ADDR=macadd] |