Operation Manual

AT-RG213 Residential VoIP Gateway - SIP Software Reference Manual
SIP Software Release 6-0-0
J613-M0524-00
90
RESET SWITCH
Syntax
RESET SWITCH
Short Syntax
RES SWITCH
Description
This command resets the switch module. All dynamic switch information is
cleared. All ports are reset. All counters and timers are reset to zero.
Examples
To reset the switch module, use the command:
RESET SWITCH
See Also
RESET SWITCH PORT
Syntax
RESET SWITCH PORT={port-list|ALL} [COUNTER]
Short Syntax
RES SWITCH PORT={port-list|ALL} [CNT]
Where:
 port-list is an identifier or a comma separated list of port identifiers. Port
identifier could be: VOIP, WAN, LAN1, LAN2 and LAN3.
Description
This command resets a port or group of ports on the switch. All packets
queued for reception or transmissions on the port are discarded, the port is
reset at the hardware level and autonegotiation of speed and duplex mode
is activated. Switch port counters are reset to zero. This command can be
used to try to ensure that packets stuck in a queue are cleared, perhaps after
a packet storm of some nature.
The PORT parameter specifies the ports to be reset.
The COUNTER parameter specifies that only switch port counters are reset.
If the COUNTER parameter is not used the switch port is fully reset.
Examples
To reset port 3, use the command:
RESET SWITCH PORT=LAN3
See Also
SET SWITCH AGEINGTIMER
Syntax
SET SWITCH AGEINGTIMER={FAST|NORMAL}
Short Syntax
S SWITCH AGET={FAST|NORMAL}