Operation Manual

Switch
SIP Software Release 6-0-0
J613-M0524-00
89
See Also
ENABLE SWITCH LEARNING
Syntax
ENABLE SWITCH LEARNING
Short Syntax
EN SWITCH LEARN
Description
This command enables the dynamic learning and updating of the
Forwarding Database. The default setting for the learning function is
enabled.
Examples
To enable the switch learning function, use the command:
ENABLE SWITCH LEARNING
See Also
ENABLE SWITCH PORT
Syntax
ENABLE SWITCH PORT={port-list|ALL} [FLOW={JAMMING|
PAUSE}[,{PAUSE|JAMMING}]]
Short Syntax
EN SWITCH PORT={port-list|ALL} [FLOW={JAM|
PAUSE}[,{PAUSE|JAM}]]
where:
 port-list is an identifier or a comma separated list of
p
ort identifiers.
Port identifier could be: WAN, LAN1, LAN2 and LAN3.
Description
This command enables a port or group of ports on the switch, or enables
one or both of the flow control mechanisms. Switch ports are enabled by
default.
Use the SET SWITCH PORT command to enable a port which has been
disabled by the Port Security function, rather than this command.
The PORT parameter specifies the port or ports to be enabled, or which are
to have flow control methods enabled.
The FLOW parameter specifies the types of flow control to be enabled for
the port. One or both types may be enabled with this command. If
JAMMING is specified, flow control for half duplex ports by asserting the
jamming signal will be enabled. If PAUSE is specified, flow control for full
duplex ports by sending PAUSE frames will be enabled. Both these forms of
flow control are enabled by default.
Examples
To enable ports LAN1 and LAN2, use the command:
ENABLE SWITCH PORT=LAN1,LAN2
See Also