User Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Chapter 1
- Overview
- Chapter 2
- Installation
- Reviewing Safety Precautions
- Cable Requirements
- Unpacking the AT-MCF2000M Management Module
- Setting the Chassis ID Jumper
- Installing the Management Module
- Cabling a Media Converter Stack
- Verifying the Installation
- Starting a Local Management Session
- Removing the AT-MCF2000M Management Module
- Installing a Media Converter Module
- Chapter 3
- Troubleshooting
- Appendix A
- Technical Specifications
AT-MCF2000M Management Module Installation Guide
23
RS-232 Terminal Port
The management module can be managed locally through
this port with a console or a PC with a terminal emulation
program. This type of management method is referred to as
local or out-of-band management because it is not
conducted over a network.
The module comes with an RS-232 Serial Management
cable for this type of management. For instructions on how
to start a local session, refer to “Starting a Local
Management Session” on page 56 or the AT-S85 and
AT-S97 Management Software Command Line User’s
Guide.
The management module does not need an Internet
Protocol (IP) address for local management.