User Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Chapter 1
- Overview
- Chapter 2
- Installation
- Reviewing Safety Precautions
- Cable Requirements
- Unpacking the AT-MCF2000M Management Module
- Setting the Chassis ID Jumper
- Installing the Management Module
- Cabling a Media Converter Stack
- Verifying the Installation
- Starting a Local Management Session
- Removing the AT-MCF2000M Management Module
- Installing a Media Converter Module
- Chapter 3
- Troubleshooting
- Appendix A
- Technical Specifications
AT-MCF2000M Management Module Installation Guide
19
Here are some of the management functions you can
perform with the module and the AT-S97 Management
Software:
Configure the operating parameters of the twisted pair
ports in the media converter channels:
– Auto-Negotiation
– Speed
– Duplex mode
– MDI/MDI-X configuration
Set the duplex mode of the fiber optic ports.
Select the operating mode of a media converter
channel:
– MissingLink
™
– Smart MissingLink
– Link Test
Establish rate limits for the ingress and egress packets
on the ports of the media converter channels.
Reset media converter modules.
View event messages.
Send event messages to a syslog server.
Manage up to sixty-four media converter modules from
one management module.
Create additional manager accounts.
Download new versions of the management software to
the management and media converter modules.
Note
For a complete list of the management features, refer
to the AT-S85 and AT-S97 Management Software
Command Line User’s Guide, available from the Allied
Telesis web site.