User guide

Overview Circuit Emulation Command Reference
10-13
iMG/RG Software Reference Manual (LAN Module Management)
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example ces set port tdm-1 lineencoding ami
10.5.1.1.6 CES SET PORT LOOPBACK
Syntax CES SET PORT <tdm_port> LOOPBACK <loopback_mode>
Description This command allows the user configure a loopback on the tdm port to facilitate fault
diagnosis.
Options The following table gives the range of values for each option, which can be specified with
this command, and a default value (if applicable).
Example ces set port tdm-1 loopback line
Option Description Default Value
Tdm_port The Physical port on the card (TDM-1 or TDM-2) -none-
encoding The line encoding to use on the line
ami
b8zs
hdb3
B8zs
Option Description Default Value
Tdm_port The Physical port on the card (TDM-1 or TDM-2) -none-
Loopback_mode The direction of the loopback to be used
none
inward: towards the pspan
line: toward the connected circuit
none