User guide

Overview HPNA Command Reference
10-3
iMG/RG Software Reference Manual (LAN Module Management)
FIGURE 10-1 HPNA Section of LAN Module Diagram
• HPNA is deployed over coax in a residence – and is capabile of carrying both data and video. In order to
ensure that the appropriate priority is observed for the different content sources, the recommended
deployment model utilizes VLANs and the associated 802.p priority bits (with a P-bit value of 5 or greated
equating to high prioirity Video). Since the end points that are recommended for use are fixed to support
VLAN 201 and 901 – it is essential that the network deployment be such that the VLANs carrying the video
and data align. Normally this is not the case within the carriers network – thus the recommendation to use
VLAN translations in order to map the appropriate services onto the 201 and 901 VLAN ids.
Note: If there is a power outage, this card can be powered down in order to conserve electricity.
10.3 HPNA Command Reference
10.3.1 Overview
This section describes the commands available on the Gateway to configure and manage the HPNA module.
0.0.1 System CLI commands
The table below lists all HPNA commands provided by the CLI: