User guide

Wireless Interface Layer 3 routing on wireless port
iMG/RG Software Reference Manual (Wireless)
9-10
swupdate set passwd friend
swupdate stop_time none
swupdate start_time minute */2 hour * day_of_month * month *
day_of_week *
#Wireless port configuration for WPA-PSK authentication with password
“friendfriend”
port wireless set Disable false
port wireless set ESSID iMG634WA-example
802.1x authenticator set authentication local
802.1x authenticator set authentication enabled
port wireless set WPAEnableWPA1 true
port wireless set WPAEnableWPA2 false
port wireless set WPA true
port wireless set WPAEnablePSK true
port wireless set WPA2EnableTKIP false
port wireless set WPA2EnableAES_CCMP true
port wireless set WPA2EnablePreauth true
port wireless set Authentication WPA-PSK
port wireless set Encryption TKIP
port wireless set WPAEnableWPA2 false
wpa set shared passphrase friendfriend
9.1.3 Layer 3 routing on wireless port
The following scenario it’s similar to the layer 2 scenario except that the traffic on CPE wireless interface is
routed to a public interface attached to the ADSL port.
In this scenario the wireless interface is member of the data VLAN together with a switch Ethernet port. Traffic
originated by the wireless host can be forwarded to the host connected at the Ethernet port or can be routed
to the uplink path where IP masquerading is performed by NAT.
In this scenario the access to the public network (the data path) is based on a PPPoEoA connection.
Please refer to chapter 2. for any information on how to configure the bridge functionality on the CPE for each
different products group.