User guide

RFC1483 RFC1483 command reference
iMG/RG Software Reference Manual (ADSL Port)
8-160
Example --> rfc1483 set transport my1483 abr
See also RFC1483 SHOW TRANSPORT
RFC1483 SET TRANSPORT BT
RFC1483 SET TRANSPORT MBS
RFC1483 SET TRANSPORT PCR
RFC1483 SET TRANSPORT SCR
8.9.1.1.13 RFC1483 SET TRANSPORT RXVCI
Syntax RFC1483 SET TRANSPORT {<name>|<number>} RXVCI <vci>
Description This command sets the receive Virtual Circuit Identifier channel. If you later set the VCI
using the RFC1483 SET TRANSPORT VCI command, the RX VCI setting will be
overridden.
The port/VCI/VPI combination must be unique for each transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
vbr
Variable Bit Rate; non-constant but predictable data trans-
port rate that uses
Non-Real-Time (NRT). You can specify
the PCR, SCR, BT and MBS for VBR traffic.
vbrrt
Variable Bit Rate Real-Time; non-constant but predictable
data transport rate that uses
Real-Time (RT). You can specify
the PCR, SCR, BT and MBS for VBRRT traffic.
abr
Available Bit Rate; non-constant and unpredictable data
transport rate that provides ATM-layer feedback and flow con-
trol.
qfc QFC: ATM flow control protocol that supports ABR.
Option Description Default Value
name An existing RFC1483 transport. To display transport
names, use the
RFC1483 LIST TRANSPORTS
command.
N/A
number An existing RFC1483 transport. To display transport num-
bers, use the
RFC1483 LIST TRANSPORTS com-
mand.
N/A
Option Description Default Value