User guide

RFC1483 RFC1483 command reference
iMG/RG Software Reference Manual (ADSL Port)
8-158
Description This command sets the port that an existing RFC1483 transport uses to transport
RFC1483 data over ATM. ATM ports are initialized in the initbun file in FlashFS, or
using the BUN SET PORT CONSOLE command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> rfc1483 set transport my1483 port a1
See also RFC1483 LIST TRANSPORTS
PORT SET
8.9.1.1.11 RFC1483 SET TRANSPORT PRILEVELS
Syntax RFC1483 SET TRANSPORT {<name>|<number>} PRILEVELS <pri-
levels>
Description This command enables support for multiple packet priority levels on the same ATM VC.
Two prilevel values are supported:
• There are no multiple priority levels enabled so the feature is disabled.
• Packets with different priorities set (such as best effort and high priority traffic) are
prioritized on the same ATM vc.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing RFC1483 transport. To display transport
names, use the
RFC1483 LIST TRANSPORTS
command.
N/A
number An existing RFC1483 transport. To display transport num-
bers, use the
RFC1483 LIST TRANSPORTS com-
mand.
N/A
atm-port The system port that is used to transport ATM data. The
port/VPI/VCI combination must be unique for each trans-
port.
N/A