User guide

PPPoA command reference PPPoA
8-143
iMG/RG Software Reference Manual (ADSL Port)
the subnet at the remote end of the PPP link. The address of this subnet is obtained dur-
ing IPCP negotiation.
Note: This command is only valid if the PPPOA SET TRANSPORT CREATEROUTE command is set to
enabled. If the CREATEROUTE COMMAND is set to disabled, no route is created and therefore the
PPPOA SET TRANSPORT SPECIFICROUTE command is ignored.
The mask for the route is calculated from the class of the remote subnet unless an alter-
native has been specified using the PPPOA SET TRANSPORT ROUTEMASK command.
If specificroute is set to disabled, a default route to the subnet at the remote end of the
PPP link is created.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoa set transport pppoa1 specificroute disabled
See also PPPOA SET TRANSPORT ROUTEMASK
PPPOA SET TRANSPORT CREATEROUTE
PPPOA LIST TRANSPORTS
PPPOA SHOW TRANSPORT
8.8.1.1.38 PPPOA SET TRANSPORT SUBNETMASK
Syntax PPPOA SET TRANSPORT {<name>|<number>} SUBNETMASK <mask>
Description This command sets the subnet mask used for the local IP interface connected to the PPP
transport. If the value 0.0.0.0 is supplied, the netmask will be calculated from the class of
the IP address obtained during IPCP negotiation.
Option Description Default Value
name An existing PPPoA transport. To display transport
names, use the
PPPOA LIST TRANSPORTS com-
mand.
N/A
number An existing PPPoA transport. To display transport num-
bers, use the
PPPOA LIST TRANSPORTS com-
mand.
N/A
enabled Allows the created route to apply to packets for the
subnet at the remote end of the PPP link.
disabled
disabled A default route to the subnet at the remote end of the
PPP link is created.