User guide

PPPoA PPPoA command reference
iMG/RG Software Reference Manual (ADSL Port)
8-136
See also PPPOA LIST TRANSPORTS
PPPOA SHOW TRANSPORT
PPPOA SET TRANSPORT USERNAME
8.8.1.1.28 PPPOA SET TRANSPORT PCR
Syntax PPPOA SET TRANSPORT {<name>|<number>} PCR <peak cell rate>
Description This command applies to existing PVC transports - it does not apply to SVC transports.
This command sets the Peak Cell Rate (PCR) for an existing PPPoA transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoa set transport pppoa2 pcr 50000
See also PPPOA SET TRANSPORT MCR
8.8.1.1.29 PPPOA SET TRANSPORT PORT
Syntax PPPOA SET TRANSPORT {<name>|<number>} PORT <port>
Description This command applies to existing PVC transports - it does not apply to SVC transports.
This command sets the port that an existing transport uses to transport PPPoA data.
The port/VPI/VCI combination must be unique for each transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoA transport. To display transport names, use
the
PPPOA LIST TRANSPORTS command.
N/A
number An existing PPPoA transport. To display transport numbers,
use the
PPPOA LIST TRANSPORTS command.
N/A
peak cell rate Determines the maximum rate at which ATM cells can be
sent along the PPPoA transport. The PCR can be any value
from 0 up to the maximum PortSpeed parameter set when
the port was created (using the initbun file in
FlashFS or
the CLI command
PORT LIST).
0
Option Description Default Value
name An existing PPPoA transport. To display transport names,
use the
PPPOA LIST TRANSPORTS command.
N/A