User guide

PPPoA command reference PPPoA
8-133
iMG/RG Software Reference Manual (ADSL Port)
Description This command sets the Link Control Protocol (LCP) maximum terminate number for an
existing PPPoA transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoa set transport pppoa1 lcpmaxterm 20
See also PPPOA SHOW TRANSPORT
PPPOA LIST TRANSPORTS
8.8.1.1.24 PPPOA SET TRANSPORT LOCALIP
Syntax PPPOA SET TRANSPORT {<name>|<number>} LOCALIP <ip-address>
Description This command is only applicable to dialin SVC or PVC transports that provide the server-
end of a connection. The command tells the PPP process the local IP address to be asso-
ciated with the client-end of an interface. This allows remote users to have dialin access
via the channel(s) that the interface is attached to.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoA transport. To display transport names, use
the
PPPOA LIST TRANSPORTS command.
N/A
number An existing PPPoA transport. To display transport numbers,
use the
PPPOA LIST TRANSPORTS command.
N/A
lcp max term
Link Control Protocol; the maximum number of consecu-
tive Terminate Requests that will be sent without reply
before assuming that the destination address is unable to
respond. The LCPfailterm can be any positive value.
2
Option Description Default Value
name An existing PPPoA transport. To display transport
names, use THE PPPOA LIST TRANSPORTS
command.
N/A
number An existing PPPoA transport. To display transport num-
bers, use the
PPPOA LIST TRANSPORTS com-
mand.
N/A