User guide

PPPoA command reference PPPoA
8-131
iMG/RG Software Reference Manual (ADSL Port)
received, the PPP connection is torn down. This functionality is also known as ‘keep-
alive’.
If you do not want to send LCP echo frames, specify zero (0) in the <interval> attribute.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoa set transport pppoa2 lcpechoevery 0
See also PPPOA SHOW TRANSPORT
PPPOA LIST TRANSPORTS
8.8.1.1.21 PPPOA SET TRANSPORT LCPMAXCONF
Syntax PPPOA SET TRANSPORT
{<name>|<number>} LCPMAXCONF <lcp max con-
figure>
Description This command sets the Link Control Protocol (LCP) maximum configure number for an
existing PPPoA transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoA transport. To display transport names,
use the
PPPOA LIST TRANSPORTS command.
N/A
number An existing PPPoA transport. To display transport num-
bers, use the
PPPOA LIST TRANSPORTS com-
mand.
N/A
interval The length of time (in seconds) between LCP echo
request frames being sent. If you do not want echo
request frames to be sent, specify ‘0’ as the interval.
10 seconds
Option Description Default Value
name An existing PPPoA transport. To display transport
names, use the PPPOA LIST TRANSPORTS
command.
N/A
number An existing PPPoA transport. To display transport
numbers, use the
PPPOA LIST TRANSPORTS
command.
N/A