User guide

PPPoA command reference PPPoA
8-121
iMG/RG Software Reference Manual (ADSL Port)
This route can either be a default route or a specific route, depending on the value set
using the PPPOA SET TRANSPORT SPECIFICROUTE command.
To d i s p l ay t h e createroute setting, use the PPPOA SHOW TRANSPORT command. The
route is removed when the PPP link is disconnected.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoa set transport pppoa1 createroute disabled
See also PPPOA SHOW TRANSPORT
PPPOA SET TRANSPORT SPECIFICROUTE
8.8.1.1.9 PPPOA SET TRANSPORT DIALIN PVC
Syntax PPPOA SET TRANSPORT
{<name>|<number>} DIALIN PVC <port> <vpi>
<vci>
Description This command sets an existing PPPoA transport to accept dialin connections over a PVC
(Permanent Virtual Circuit). This replaces the transports existing dialin/dialout setting
over PVC/SVC. The PVC uses the interface that was specified when the transport was
created.
The command allows you to specify the following PVC information:
• The ATM port that will transport data
•VPI (Virtual Path Identifier)
•VCI (Virtual Circuit Identifier)
The port/VPI/VCI combination must be unique for each transport.
Option Description Default Value
name An existing PPPoA transport. To display transport names, use
the
PPPOA LIST TRANSPORTS command.
N/A
enabled Adds a route to the system after IPCP negotiation. enabled
disabled Does not add a route to the system after IPCP negotiation.