User guide

PPPoA PPPoA command reference
iMG/RG Software Reference Manual (ADSL Port)
8-120
Example --> pppoa set transport pppoa1 autoconnect enabled
See also PPPOA LIST TRANSPORTS
8.8.1.1.7 PPPOA SET TRANSPORT BT
Syntax PPPOA SET TRANSPORT {<name>|<number>} BT <burst tolerance>
Description This command applies to existing PVC transports - it does not apply to SVC transports.
This command sets the Burst Tolerance (BT) for an existing PPPoA transport. This com-
mand is only valid if you set VBR or VBR RT as the QoS Class using the PPPOA SET
TRANSPORT QOSCLASS command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoa set transport pppoa1 bt 5
See also PPPOA SET TRANSPORT MBS
8.8.1.1.8 PPPOA SET TRANSPORT CREATEROUTE
Syntax PPPOA SET TRANSPORT {<name>|<number>} CREATEROUTE
{ENABLED|DISABLED}
Description This command specifies whether a route is added to the system after IPCP (Internet
Protocol Control Protocol) negotiation is completed. If set to enabled, a route will be
created which directs packets to the remote end of the PPP link.
disabled Disables PPPoA autoconnect.
Option Description Default Value
name An existing PPPoA transport. To display transport
names, use the PPPOA LIST TRANSPORTS com-
mand.
N/A
number An existing PPPoA transport. To display transport num-
bers, use the
PPPOA LIST TRANSPORTS com-
mand.
N/A
burst tolerance
Controls the duration of traffic bursts on VBR (
Var i-
able Bit Rate
) and VBR RT (VBR Real Time) chan-
nels. This value overrides an existing MBS value (if set).
The BT can be any value between 0 and 100.
0
Option Description Default Value