User guide

PPPoE command reference PPPoE
8-107
iMG/RG Software Reference Manual (ADSL Port)
Description This command specifies whether the route created when a PPP link comes up is a specific
or default route. If set to enabled, the route created will only apply to packets for the
subnet at the remote end of the PPP link. The address of this subnet is obtained during
IPCP negotiation.
Note: This command is only valid if the PPPOE SET TRANSPORT CREATEROUTE command is set to
enabled. If the CREATEROUTE command is set to disabled, no route is created and therefore
the PPPOE SET TRANSPORT SPECIFICROUTE command is ignored.
The mask for the route is calculated from the class of the remote subnet unless an alter-
native has been specified using the PPPOE SET TRANSPORT ROUTEMASK command.
If specificroute is set to ‘disabled’, a default route to the subnet at the remote end of the
PPP link is created. Note that the current setting of this command is ignored if PPPOE
SET TRANSPORT CREATEROUTE command is set to disabled.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 specificroute disabled
See also PPPOE SET TRANSPORT ROUTEMASK
PPPOE SET TRANSPORT CREATEROUTE
PPPOE LIST TRANSPORTS
8.7.4.1.50 PPPOE SET TRANSPORT START/STOP TEST
Syntax PPPOE SET TRANSPORT {<name>|<number>} START/STOP TEST
Description This command starts and stops a PPPoE test on a transport.
Option Description Default Value
name An existing PPPoE transport. To display transport
names, use the PPPOE LIST TRANSPORTS com-
mand.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
enabled Allows the created route to apply to packets for the
subnet at the remote end of the PPP link.
disabled
disabled A default route to the subnet at the remote end of the
PPP link is created.