User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-98
Example --> pppoe set transport pppoe2 pcr 50000
See also PPPOE SET TRANSPORT MCR
8.7.4.1.39 PPPOE SET TRANSPORT PRILEVELS
Syntax PPPOE SET TRANSPORT {<name>|<number>} PRILEVELS <prilevels>
Description This command enables support for multiple packet priority levels on the same ATM VC.
Two prilevel values are supported:
• There are no multiple priority levels enabled so the feature is disabled.
• Packets with different priorities set (such as best effort and high priority traffic) are
prioritized on the same ATM VC.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the
PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
peak cell rate Determines the maximum rate at which ATM cells may be
sent along the PPPoE transport. The PCR can be any value
from 0 up to the maximum PortSpeed parameter set when
the port was created (using the initbun file in FlashFS or the
CLI command
PORT SET).
0
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the
PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
prilevels The number of priority levels available on an ATM trans-
port.
1