User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-94
Example --> pppoe set transport pppoe1 localip 192.168.103.2
See also PPPOE SHOW TRANSPORT
PPPOE LIST TRANSPORTS
PPPOE SET TRANSPORT REMOTEIP
8.7.4.1.33 PPPOE SET TRANSPORT MANUALCONNECT
Syntax PPPOE SET TRANSPORT
{<name>|<number>} MANUALCONNECT
{ENABLED|DISABLED}
Description This command enales/disables the manual connect option for a givien PPPoE transport.
In this mode, the connection to the network is initiated manually through a GUI request
of a CLI command and by default, terminates only when done so explicitly by a user, dur
ot power loss, or when the connection is lost.
When the manual connect option is enabled, the autoconnect feature of the device is
automatically disabled.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 manualconnect enabled
Description PPPOE LIST TRANSPORTS
PPOE SET TRANSPORT LCPECHOEVERY
ip-address The IP address of the local ‘client-end’ of an interface dis-
played in the following format: 111.222.254.4
0.0.0.0
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the
PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
enabled Enable the “manualconnect” option Disabled
disabled Disable the “manualconnect” option