User guide

PPPoE command reference PPPoE
8-93
iMG/RG Software Reference Manual (ADSL Port)
Description This command sets the Link Control Protocol (LCP) maximum terminate number for an
existing PPPoE transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 lcpmaxterm 20
See also PPPOE SHOW TRANSPORT
PPPOE LIST TRANSPORTS
8.7.4.1.32 PPPOE SET TRANSPORT LOCALIP
Syntax PPPOE SET TRANSPORT {<name>|<number>} LOCALIP <ip-address>
Description This command tells the PPP process the local IP address to be associated with the client-
end of an interface. This enables remote users to have dialin access via the channel(s) that
the interface is attached to.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Option Description Default Value
name An existing PPPoE transport. To display transport
names, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
lcp max term Link Control Protocol: the maximum number of consecu-
tive Terminate Requests that will be sent without reply
before assuming that the destination address is unable
to respond. The LCPfailterm can be any positive value.
2
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the
PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A