User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-92
Example --> pppoe set transport pppoe1 lcpmaxconf 20
See also PPPOE SHOW TRANSPORT
PPPOE LIST TRANSPORTS
8.7.4.1.30 PPPOE SET TRANSPORT LCPMAXFAIL
Syntax PPPOE SET TRANSPORT
{<name>|<number>} LCPMAXFAIL <lcp max
fail>
Description This command sets the Link Control Protocol (LCP) maximum fail number for an existing
PPPoE transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe1 lcpmaxfail 20
See also PPPOE SHOW TRANSPORT
PPPOE LIST TRANSPORTS
8.7.4.1.31 PPPOE SET TRANSPORT LCPMAXTERM
Syntax PPPOE SET TRANSPORT
{<name>|<number >} LCPMAXTERM <lcp max termi-
nate>
lcp max configure Link Control Protocol: the maximum number of configures
that can be transmitted without reply before assuming
that the destination address is unable to respond. The
LCPmaxconf can be any positive value.
10
Option Description Default Value
name An existing PPPoE transport. To display transport
names, use the
PPPOE LIST TRANSPORTS com-
mand.
N/A
number An existing PPPoE transport. To display transport num-
bers, use
THE PPPOE LIST TRANSPORTS com-
mand.
N/A
lcp max fail Link Control Protocol: the maximum number of consecu-
tive negative acknowledgements (indicating that the
information received contains errors) that can be trans-
mitted before assuming that parameter negotiation is
not converging. The LCPmaxfail can be any positive
value.
5