User guide

PPPoE PPPoE command reference
iMG/RG Software Reference Manual (ADSL Port)
8-90
Example --> pppoe set transport pppoe1 idletimeout 20
See also PPPOE LIST TRANSPORTS
PPOE SET TRANSPORT LCPECHOEVERY
8.7.4.1.27 PPPOE SET TRANSPORT INTERFACE
Syntax PPPOE SET TRANSPORT {<name>|<number>} INTERFACE <interface>
Description This command sets the PPP interface for an existing PPPoE transport.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example --> pppoe set transport pppoe2 interface 4
See also PPPOE SHOW TRANSPORT
PPPOE LIST TRANSPORTS
8.7.4.1.28 PPPOE SET TRANSPORT LCPECHOEVERY
Syntax PPPOE SET TRANSPORT
{<name>|<number>} LCPECHOEVERY <interval>
Description This command tells a specified PPP transport to send an LCP (Link Control Protocol) echo
request frame at specified intervals (in seconds). If no reply to the request is received,
the PPP connection is torn down. This functionality is also known as ‘keep-alive’.
If you do not want to send LCP echo frames, specify zero (0) in the <interval> attribute.
idletimeout The length of time (in minutes) that a PPPoE session con-
nected to an ISP can remain idle before the session is dis-
abled. The time can be any value between 0 and 60. A
value of 0 means that no idletimeout is set.
0
Option Description Default Value
name An existing PPPoE transport. To display transport names,
use the PPPOE LIST TRANSPORTS command.
N/A
number An existing PPPoE transport. To display transport num-
bers, use the PPPOE LIST TRANSPORTS com-
mand.
N/A
interface The PPP interface to a channel that transports PPPoE data.
Multiple channels can use a single interface. The interface
value can be any positive integer.
N/A