User guide

Software update Emergency command reference
iMG/RG Software Reference Manual (System Configuration)
1-54
See also EMERGENCY SET IPINTERFACE GATEWAY
EMERGENCY SHOW
EMERGENCY UPDATE
1.3.4.1.7 EMERGENCY SHOW
Syntax EMERGENCY SHOW
Description
This command displays the current emergency configuration settings. These settings are not active
until the EMERGENCY UPDATE command is entered or the Residential Gateway configuration is
saved and then the system is restarted.
Example emergency show
EMERGENCY CONFIGURATION
- GENERAL PARAMETERS
device ip address: 192.168.1.1
device netmask: 255.255.255.0
gateway ip address: 192.168.1.254
vlan tag id: 2
vlan tagged port: LAN4
Syntax EMERGENCY UPDATE
1.3.4.1.8 EMERGENCY UPDATE
Syntax EMERGENCY UPDATE
Description This command update the Residential Gateway e2prom with the new emergency config-
uration data. To display the current emergency configuration settings use the EMER-
GENCY SHOW command.
Example emergency update
See also EMERGENCY SHOW
1.4 Software update
Gateway software consists of the Main Application code plus additional support files and the Recovery Applica-
tion code. All these files are stored permanently into the flash memory under the main partition or recovery
partition depending on the file type.
To upgrade software or simply load into the gateway a specific file, it's possible use one of the following solu-
tions depending on the type of upgrade requested:
• Web Interface, when available is designed to update the Main Application code or the Recovery Application
code. Web interface is available only on the main code (not on recovery)